01
Phone Triage
You call (513) 982-0535 and describe the symptom: not cooling, leaking water, ice maker not working, freezer not freezing, compressor short-cycling. We ask the box type, the brand and the current temperature. That tells us whether to send a standard van or a truck stocked for a compressor or control board job. Takes about five minutes.
02
On-Site Diagnosis
A technician arrives with a multimeter, clamp meter, refrigerant gauges, leak detector and thermal imaging camera. He reads amp draw at the compressor, checks suction and head pressure, scans the evaporator for hot spots and tests the defrost heater, thermal fuse and control board. Most diagnoses finish in 30 to 45 minutes.
03
Quote And Approval
You get a flat price for the repair, parts and labor together. If the fix is a $180 gasket swap, we say so. If the compressor is gone and a replacement runs $900 to $1,400, we say that too, and we tell you when replacement beats repair. Nothing happens until you approve.
04
Repair And Test
We pull the failed part, install the replacement, evacuate and recharge the system if refrigerant work is needed, and run the box for a full cycle. A typical gasket or valve job takes one to two hours. Compressor swaps run three to five hours. We clean up and haul the old part out with us.
05
Temperature Sign-Off
Before we leave, we log holding temperature with a calibrated probe: 38 degrees or below for coolers, 0 degrees for freezers. You get the before-and-after numbers in writing for your records. If the box needs 24 hours to pull down fully, we tell you what to watch and follow up the next day.